4/22/2024 0 Comments Iei 212se keypadThis warranty shall expire two years after shipping date for DOOR-GARD keypads.Įxcept as stated above, IEI makes no warranties, either express or implied, as to any matter whatsoever, including, without limitation to, the condition of its products, their merchantability, or fitness for any particular purpose. IEI will not be liable to the purchaser or anyone else for incidental or consequential damages arising from any defect in, or malfunction of, its products. IEI’s sole liability is limited to the repair or (at IEI’s option) the replacement of the defective product or part when sent to IEI’s facility (freight and insurance charges prepaid), after first obtaining IEI’s Return Merchandise Authorization. IEI-293 THREERELAYPLUG-INBOARDwith FORM C,1 amp relays. Lighting kit available as an option 10-30 VDC 12-24 VAC auto adjusting. Durable metal Braille keys Available in white. One piece housing suitable for wall, post, or gooseneck mounting. INSTALLATION IEI-280 WEATHERPROOFSURFACEBACKBOX. Weatherproof, self-contained metal housing Vandal resistant. Interfaces with any parallel printer for user/door activity logging. IEI does not assume any responsibility for damage or injury to person or property due to improper care, storage, handling, abuse, misuse, normal wear and tear, or an act of God. and outputs for up to 8 DoorGard Keypads. (IEI) warrants its products to be free from defects in material and workmanship, when they have been installed in accordance with the manufacturer’s instructions, and have not been modified or tampered with. On SE keypad, holes have also been spotted inside the front housing for additional LEDs (LEDs not included).To speed installation of the SE keypad, holes have been spotted on the inside the back housing for mounting to a wall or a single-gang electrical box.For use in extreme weather conditions, consult the factory for additional methods of protecting your keypad.This allows air to circulate and a place for condensation to drain. Do not seal the drain holes at the bottom of the keypad housing.Use the included tie wrap to bundle all the wires together from the keypad wire harness and relay board. The relays must face up towards the keypad wire harness connector P2. Do not silicone the cover plate because the unit will not seal properly. To install the relay board, plug the relay board onto P3 on the keypad. This helps prevent water from entering the case and condensing on the circuit board. IEI 212i Indoor Flush Mount Keypad Documentation 212i Keypad Wiring Diagram and Specifications 212i Features and Programming Guide IEI 212iLW & 242iLW. When mounting this unit outside, apply silicone to the area where the wires enter the case.The bi-color LED provided with the SE keypad illuminates red when the LockRelease relay is de-energized and green when the relay is de-energized.To avoid ESD (Electro-Static Discharge) interfering with the operation of the keypad, ground the housing to earth ground.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |